增加屏幕支持

code/firmware/variants/esp32c3/diy/esp32c3_moonshine/variant.h

@@ -29,6 +29,9 @@
 #endif
 
 #define USE_LLCC68
+#define USE_SX1262
+#define USE_SX1268
+
 #define LORA_SCK 10
 #define LORA_MISO 6
 #define LORA_MOSI 7
@@ -43,4 +46,6 @@
 #define SX126X_BUSY LORA_BUSY
 #define SX126X_RESET LORA_RESET
 #define SX126X_DIO2_AS_RF_SWITCH
-#define SX126X_DIO3_TCXO_VOLTAGE 1.8
+#define SX126X_DIO3_TCXO_VOLTAGE 1.8
+
+#define TCXO_OPTIONAL

code/firmware/variants/esp32c3/diy/esp32c3_moonshine_mv/platformio.ini

@@ -9,6 +9,8 @@ build_flags =
   ${esp32c3_base.build_flags}
   -D PRIVATE_HW
   -I variants/esp32c3/diy/esp32c3_moonshine_mv
+  -D ARDUINO_USB_MODE=1
+  -D ARDUINO_USB_CDC_ON_BOOT=1
 monitor_speed = 115200
 upload_protocol = esptool
 ;upload_port = /dev/ttyUSB0

code/firmware/variants/esp32c3/diy/esp32c3_moonshine_mv/variant.h

@@ -5,10 +5,20 @@
 // https://resource.heltec.cn/download/HT-DEV-ESP/HT-DEV-ESP_V3_Sch.pdf
 
 
-#define LED_POWER 12    // LED
+#define LED_POWER 13    // LED
 #define LED_STATE_ON 1 // State when LED is lit
 
-#define HAS_SCREEN 0
+
+#define HAS_SCREEN 1
+#define USE_SSD1306
+
+#define HAS_I2C 1
+#define WIRE_INTERFACES_COUNT (1)
+#define I2C_SDA 0
+#define I2C_SCL 1
+
+
+
 #define HAS_GPS 0
 #undef GPS_RX_PIN
 #undef GPS_TX_PIN
@@ -22,6 +32,9 @@
 #endif
 
 #define USE_LLCC68
+#define USE_SX1262
+#define USE_SX1268
+
 #define LORA_SCK 10
 #define LORA_MISO 6
 #define LORA_MOSI 7
@@ -36,4 +49,6 @@
 #define SX126X_BUSY LORA_BUSY
 #define SX126X_RESET LORA_RESET
 #define SX126X_DIO2_AS_RF_SWITCH
-#define SX126X_DIO3_TCXO_VOLTAGE 1.8
+#define SX126X_DIO3_TCXO_VOLTAGE 1.8
+
+#define TCXO_OPTIONAL