* fix(stm32/russell): define ENABLE_HWSERIAL2 and Serial2 pins
The Russell board variant was missed during Initial serialModule cleanup
(PR #9465), which began requiring Serial2 to be explicitly defined via
ENABLE_HWSERIAL2 and PIN_SERIAL2_TX/RX rather than relying on implicit
defaults, causing a build error.
Signed-off-by: Andrew Yong <me@ndoo.sg>
* feat(stm32/russell): add BME680 support, exclude modules to fit flash
The BME680 is hardware footprint compatible with the BME280 already
present on the Russell board, so add it as an additional lib dep to
enable environment sensing (temperature, humidity, pressure,
gas resistance).
The STM32 target has very limited flash. Even traceroute alone causes
overflow, so the following modules are excluded to stay within budget:
- RANGETEST
- DETECTIONSENSOR
- EXTERNALNOTIFICATION
- POWERSTRESS
- NEIGHBORINFO
- TRACEROUTE
- WAYPOINT
AIR_QUALITY_SENSOR is also excluded as it requires the BSEC2 library
for real IAQ output, which alone overflows flash by ~44KB on this
target. The Adafruit BME680 library is used instead for raw sensor
readings.
Signed-off-by: Andrew Yong <me@ndoo.sg>
---------
Signed-off-by: Andrew Yong <me@ndoo.sg>
Co-authored-by: Jonathan Bennett <jbennett@incomsystems.biz>
Co-authored-by: Ben Meadors <benmmeadors@gmail.com>
Integrate STM32 battery monitoring into AnalogBatteryLevel, supporting
external GPIO ADC pins as well as internal VBAT channel.
Features:
- ADC reading using STM32 LL (Lower Layer) macros supporting external
ADC channels and internal VBAT channel (AVBAT)
- ADC compensation using STM32 LL macros with factory-calibrated VREFINT
(AVREF) for accurate voltage measurement
- LFP battery OCV curve for STM32WL using AVBAT (STM32 VDD absolute
maximum supply voltage 3.9V, direct connection of Li-Po batteries is
not supported)
Internal VBAT channel implemented in:
- Russell
- RAK3172
In these variants, ADC_MULTIPLIER = (1.01f * 3) = 3.30 as there is a
3:1 internal divider (DS13105 Rev 12 §5.3.21), and a bit of tolerance
as the actual 10% spec leads to readings much too high.
Assisted-by: Claude:sonnet-4-5
Signed-off-by: Andrew Yong <me@ndoo.sg>
