AustinandGitHub
fcb9ec0c2d
Fixes issues with #includes inherited from `configuration.h` when building for pioarduino. Aligns t5s3_epaper with other variants like t_deck_pro.
40 lines
1.6 KiB
C++
40 lines
1.6 KiB
C++
#include "variant.h"
|
|
#include "Arduino.h"
|
|
#include "pins_arduino.h"
|
|
|
|
void earlyInitVariant()
|
|
{
|
|
pinMode(LORA_CS, OUTPUT);
|
|
digitalWrite(LORA_CS, HIGH);
|
|
pinMode(SDCARD_CS, OUTPUT);
|
|
digitalWrite(SDCARD_CS, HIGH);
|
|
pinMode(BOARD_BL_EN, OUTPUT);
|
|
|
|
// Program GT911 touch controller to I2C address 0x14 (GT911_SLAVE_ADDRESS_H) before
|
|
// the I2C bus scan runs. GPIO3 (INT) defaults LOW on ESP32-S3 cold boot, which would
|
|
// leave the GT911 at 0x5D (GT911_SLAVE_ADDRESS_L) — the same address as the SFA30
|
|
// air quality sensor — causing a false-positive SFA30 detection during the I2C scan.
|
|
//
|
|
// GT911 datasheet §4.3 "Address Selection":
|
|
// Pull INT HIGH before releasing RST → device latches address 0x14 (SLAVE_ADDRESS_H)
|
|
// Pull INT LOW before releasing RST → device latches address 0x5D (SLAVE_ADDRESS_L)
|
|
// Minimum RST assert time: 100 µs; minimum startup time after RST deassert: 5 ms.
|
|
//
|
|
// lateInitVariant() calls touch.begin() which repeats this sequence internally while
|
|
// also performing full I2C initialisation; the double-reset is harmless.
|
|
pinMode(GT911_PIN_RST, OUTPUT);
|
|
digitalWrite(GT911_PIN_RST, LOW);
|
|
pinMode(GT911_PIN_INT, OUTPUT);
|
|
digitalWrite(GT911_PIN_INT, HIGH); // HIGH → latch address 0x14
|
|
delay(1); // > 100 µs
|
|
digitalWrite(GT911_PIN_RST, HIGH);
|
|
delay(10); // > 5 ms startup
|
|
pinMode(GT911_PIN_INT, INPUT); // release INT for interrupt use
|
|
}
|
|
|
|
void variant_shutdown()
|
|
{
|
|
// Ensure frontlight is off during deep sleep
|
|
digitalWrite(BOARD_BL_EN, LOW);
|
|
}
|